Hebel Rendering - Know More About the Process

Hebel Rendering is a fantastic way to set up the much-needed shield of protection on the walls of your house. It works in a significant way - and there is no doubt in it. However, it only goes that way when have had it done perfectly.

Well, you are not going to do it yourself if you are not an expert. In all probability, you will appoint a rendering company that will do it for you. Nevertheless, you have to know certain technicalities, which will give you a notion of things that are to be done during Hebel Rendering.

In other words, you need to be prepared from your end with enough knowledge as this will help you to evaluate the work done by the rendering company.

The First Step - Preparation of Base

The initial step involves filling the crevices and holes and repairing the imperfection of the panels with the help of patch materials. This ensures that the base is prepared correctly, for a flawless and proper application of the thin film of the base render.

Once the repair work is completed, enough time is given to it to dry thoroughly, before base rendering commences. In case you find the panels are out of order or are misaligned you need to have them back in order, with the help of the levelling plane, or with the help of sanding float. For finishing the external corners, and reinforcing them, fibreglass beads are usually rendered around their nooks and crannies.

Applying the Base Layer

Now, it is time for the rendering company in Mackay to apply the base coat. The thickness of the base coat should be such that the desired final coating can be applied to it without any problem whatsoever. All the panels and their corners of the doors and windows are at the same time reinforced with the help of 200 mm reinforcing tape, which is embedded into the wet render. It should be done just underneath the surface when applying the skim-coat.

Applying the Final Layer

At last, it is time to apply the final layer. Suitable thickness level must be attained, so that the surface attains the desired finish and becomes suitable for texture coating or painting. Control joints are filled or caulked by a paintable sealant made up of polyurethane.

Once done, the surface is left to dry up for at least 4 days after which, the overcoating is applied. In case the surface dries up too quickly due to climatic conditions, it may need further misting with water. This will help in hydration, and will make the surface stronger and will increase the durability of the layer.

Texturing

Finally, it is time for the specialists to apply the texturing, or in other words, the textured finish. The colour is selected as well. You can go for the trowel-on textured finish or the roll-on variety. Ideally, before the texturing is done, the final coat is given at least 24 hours to dry up.  

So now that you have a somewhat formidable knowledge about Hebel Rendering, you can talk to the specialists from rendering companies in Brisbane with confidence and put across your thoughts and ideas with more authority.